MULTI-CW-VS

Description : this is a block that allows to simulate a CW RF voltage or current source for driven antenna array simulation.

This source is mainly used in CW simulation mode, see Simcontroller

Figure: CW-VS Diagram block


The output envelope Yn of the block is :

Yn is the amplitude/Phase description of the nth output of the bloc. The number N of the available outputs is chosen by the way of the cardinality option of this bloc. Right clic on the port in order to edit the cardinality.

Figure: Block cardinality


Figure: Dialog Box


￭ Signal type: Complex signal (envelope) or real (real part of envelope).

￭ Signal amplitude units: dBm or volts. If dBm the reference impedance "Resistance" is used within the following equation:

￭ Amplitude and phase. These values are restricted to a list of variables define thanks EQN or VAR block. See Setup Antenna schematic for the utilisation of these parameters.