Jump to main content
  • VISION 2.4.2
  • Getting started with Device Modeler
  • Getting started with System Architect
  • System Information
  • About
Index
  1. Home
  2. VISION 2.4.2
  3. System Architect
  4. Palette
  5. Linear lumped
  • VISION 2.4.2
    • VISION Home
    • Device Modeler
    • System Architect
      • Create or select a schematic

      • Create a multiblock and add to Palette

        How to create a multiblock? This block is useful to build severals model in parallel or to hide cascaded blocks into a sub-schematic to make your design more readable. Also, you will learn how to define a multiblock as a new block available in the Palette.

      • Palette
        • Connectors
        • Co-simulation
        • Linear distributed
        • Linear lumped
          • CIRCULATOR
          • COUPLER
          • GROUND
          • ISOLATOR
          • CAP1P
          • CAP
          • IND1P
          • IND
          • IMP1P
          • IMP
          • ERHO1P
          • ERHO
          • RES1P
          • RES
        • Multiblock
        • Nonlinear
        • Probe
        • Scope
        • Simulation controls
        • Source
        • Transducer
    • Whiteboard
    • Toolboxes
    • Scripting
    • Release Note

Linear lumped

This library contains the following blocks:
  • CIRCULATOR
  • COUPLER
  • GROUND
  • ISOLATOR
  • CAP1P
  • CAP
  • IND1P
  • IND
  • IMP1P
  • IMP
  • ERHO1P
  • ERHO
  • RES1P
  • RES
© Copyright 2018-2024 by AMCAD Engineering
Documentation VISION 2.4.2 - version 1.1 - rev1 - 2024/11/27