Jump to main content

VISION 2.4.2
Getting started with Device Modeler
Getting started with System Architect
System Information
About

Home
VISION 2.4.2
System Architect
Palette
Linear lumped
IMP1P

VISION 2.4.2
- VISION Home
- Device Modeler
- System Architect
  - Create or select a schematic
  - Create a multiblock and add to Palette
    How to create a multiblock? This block is useful to build severals model in parallel or to hide cascaded blocks into a sub-schematic to make your design more readable. Also, you will learn how to define a multiblock as a new block available in the Palette.
  - Palette
    - Connectors
    - Co-simulation
    - Linear distributed
    - Linear lumped
      - CIRCULATOR
      - COUPLER
      - GROUND
      - ISOLATOR
      - CAP1P
      - CAP
      - IND1P
      - IND
      - IMP1P
      - IMP
      - ERHO1P
      - ERHO
      - RES1P
      - RES
    - Multiblock
    - Nonlinear
    - Probe
    - Scope
    - Simulation controls
    - Source
    - Transducer
- Whiteboard
- Toolboxes
- Scripting
- Release Note

IMP1P

IMP1P- Impedance model connected to ground

Figure: Block diagram

Figure: Dialog box

Impedance: Real part of Z + Imaginary part of Z defined in the following diagram with v2 grounded.

Add noise:

© Copyright 2018-2024 by AMCAD Engineering

Documentation VISION 2.4.2 - version 1.1 - rev1 - 2024/11/27