Jump to main content

VISION 2.4
Getting started with Device Modeler
Getting started with System Architect
System Information
About

Home
VISION 2.4
System Architect
Palette
Probe
PaddEff

VISION 2.4
- VISION Home
- Device Modeler
- System Architect
  - Create or select a schematic
  - Create a multiblock and add to Palette
    How to create a multiblock? This block is useful to build severals model in parallel or to hide cascaded blocks into a sub-schematic to make your design more readable. Also, you will learn how to define a multiblock as a new block available in the Palette.
  - Palette
    - Connectors
    - Co-simulation
    - Linear distributed
    - Linear lumped
    - Multiblock
    - Nonlinear
    - Probe
      - NF band
      - Power Average
      - ACPR
      - CW NF
      - PMeter
      - PaddEff
      - RfGain
      - TransGain
      - WMeter
      - MEAN VALUE
      - AVERAGE PAE
      - PAPR
      - IQ PROBE
    - Scope
    - Simulation controls
    - Source
    - Transducer
- Whiteboard
- Toolboxes
- Scripting
- Release Note

PaddEff

PaddEff - Power added Efficiency probe.

Figure: Diagram block

Perform the following calculus :

with general mean power calculus for power In and Out :

© Copyright 2016-2023 by AMCAD Engineering

Documentation VISION 2.4 - version 1.0 - rev1 - 2023/11/16