Jump to main content

VISION 2.4
Getting started with Device Modeler
Getting started with System Architect
System Information
About

Home
Getting started with System Architect
Perfom noise analysis

Getting started with System Architect
- Perform CW simulation
  How to perform CW simulation. A CW simulation only allows for taking into account the steady-state of the system response. The CW simulation considers that the envelope signal varies slowly over time, with regard to time constants of the system. A CW simulation is much faster than a transient simulation, however it is only possible for CW pulse type excitation, with constant (or slow) amplitude and frequency transition.
- Perform Transient simulation
  How to perform transient simulation. The transient simulation in VISION allows to obtain the time domain response of a non-linear circuit excited by a modulated complex signal.
- Perform Sweep Analysis
- Perfom noise analysis
  - Perform time domain noise analysis
    How to perform time domain noise analysis. A time domain noise analysis is performed in transient mode simulation. This allows for simulations where the signals at all nodes of the system comes from the contribution of source signal and the noise.
  - Perform frequency domain noise analysis
    How to perform frequency domain noise analysis. A frequency domain noise analysis is performed in CW mode simulation. It corresponds to the calculation of the disturbance by a small signal noise of the HB CW. When the system is purely linear, it corresponds exactly to a noise analysis of AC type simulation on commercial circuit simulator. In this mode the noise is processed distinctly from the signal, which allows a very fast and accurate noise calculation.
- Perform statistical analysis
  How to perform statistical analysis. Statistical analysis makes it possible to perform a simulation in which variables or models follow a statistical law.
- Perform model export
  How to perform a model export from System Architect application. The model export make possible to use a model outside from VISION environnment in order to use other kind of analysis tool. The model export is currently interfaced with SystemVue, VSS, Simulink and the Comlib2 module.
- Perform antenna analysis
- Perform co-simulation with Matlab
  How to perform co-simulation with Matlab. VISION allows to set up co-simulation process using Matlab API block.
- Perform 2-tone simulation
  How to perform 2-tone simulation. 2-tone simulation in VISION allows to obtain time domain response of nonlinear circuit excited by 2-tone complex signal varying in frequency spacing and average power.
- Perform Transient simulation based on IQ measurement
  This manual describes the procedure for using IQ measurements obtained from IQSTAR software to perform transient simulation. The transient simulator in VISION allows for obtaining the time domain response of a non-linear circuit excited by a modulated complex signal which can then be compared to measurement data from IQSTAR.

Perfom noise analysis

Documentation VISION 2.4 - version 1.0 - rev1 - 2023/11/16