AMCAD address two different kinds of customers:

Foundries

Founders usually look for the best modeling methodologies/tools, in order to increase their technology knowledge, since our models bring precious informations on the components under tests. These informations can be used to improve the process of component manufacturing.

The aim is also provide accurate models to the final user, because efficient design cannot be done without good models.

Original Equipment Manufacturers

When the models provided by the foundry are not accurate enough, then the EOM can ask for a better model, that will be specifically dedicated to the final application. This is typically the case for space products, where the circuits performances must use all the potentialities offered by the components embedded into the circuit.